Elmomc AC Input Digital Servo Drives-Cornet Manuel d'utilisateur télécharger pdf (Page 4)

Harmonica and Bassoon Cable Kits

MAN-CBLKIT- (Ver. 3.4)

1. Introduction

This document provides the wiring details for the cables used to connect Elmo Harmonica

and Bassoon digital servo drives with the end-user application. The servo drive-side

pinouts are provided in Chapter 3 of the installation guide for each drive.

The cables come in two lengths: 2 meters (6.5 feet) or 5 meters (16.5 feet). The default

length is 2 meters. Other lengths are indicated by an extended suffix in the cable part

number. Thus, cable part number CBL-MTRENC1 indicates a 2-meter cable and cable part

number CBL-MTRENC1-5 indicates a 5 meter cable.

CBL-RJ45CAN2 is an exception to the part number convention described above.

For CBL-RJ45CAN2, the 2 suffix designates a 20 cm cable.

1.1 Harmonica Connectors

The table below presents the connector panel of the Harmonica drive and specifies the

cable connectors.

Pins Type

Connector Manufacturer

and Part Number

Port Connector Location

8 RJ-45

RJ-45 plug

8 2 mm Pitch Molex 35507-0800 J2

12 2 mm Pitch Molex 35507-1200 J3

2 2 mm Pitch Molex 35507-0200 J4

8 2 mm Pitch Molex 35507-0800 J5

4 2 mm Pitch Molex 35507-0400 J6

3 2 mm Pitch Molex 35507-0300 J7

5.08 mm Pitch

Terminal

Block

Phoenix MSTB 2.5/7-ST-5.08

Table 1-1: Connectors on the Harmonica Drive

Auxiliary

Power

Digital

Output

Analog

Input

Communication

Feedback B

Feedback A

Digital

Input

J8: Main

Power

1-1

1 2 3 4 5 6 7 8 9 ... 21 22

Commentaires sur ces manuels

Pas de commentaire

Elmomc AC Input Digital Servo Drives-Cornet Manuel d'utilisateur Page 4

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel Elmomc AC Input Digital Servo Drives-Cornet