Elmomc Multi-Axis Motion Controller-Maestro Installation Manuel d'utilisateur télécharger pdf (Page 20)

3.5 D-sub Cable Assemblies

The Maestro features easy-to-use D-sub type connections for various cables. These cables are

available from Elmo. The instructions and diagrams below are designed to help customers

who wish to build their own cables.

 Use 24, 26 or 28 AWG twisted-pair shielded cables (24 AWG cable is recommended). For

best results, the shield should have aluminum foil covered by copper braid.

 Use only a D-sub connector with a metal housing.

 Attach the braid shield tightly to the metal housing of the D-type connector.

 On the device side, ground the shield.

Figure

3-5: I/O Cable Assemblies

Note: All D-sub type connectors used with the Maestro should be assembled in this way.

Metal Housing

Verify that the braid shield is in tight

contact with the metal housing

Maestro Installation Guide Installation

MAN-MASIG (Ver 1.33)

3-10

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 45 46

Pas de commentaire

Elmomc Multi-Axis Motion Controller-Maestro Installation Manuel d'utilisateur Page 20