Elmomc Multi-Axis Motion Controller-Maestro Installation Manuel d'utilisateur télécharger pdf (Page 25)

Maestro Installation Guide Installation

MAN-MASIG (Ver 1.33)

3-15

Maestro

Power Supply

Figure 3-7: Power Supply (24v) Connection Diagram

3.7 Powering Up

After the Maestro has been mounted, check that the cables are intact. The Maestro is then

ready to be powered up.

3.8 Initializing the System

After the Maestro has been connected and mounted, the system must be set up and

initialized. The minimum system requirements for a setup are:

• Maestro (and power supply)

• PC (with Elmo Studio and Composer)

• At least one Drive and Motor

• Terminated CAN network

Setting up the drives and motors is described in the

Simpliq Servo Drive Installation Guide and

Composer User's Guide. Advanced features are described in the SimplIQ Software Manual,

Interlude API User Guide, SimplIQ Command Reference and CANopen Implementation Guide.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 45 46

Pas de commentaire

Elmomc Multi-Axis Motion Controller-Maestro Installation Manuel d'utilisateur Page 25