Elmomc AC Input Digital Servo Drives-Tuba Manuel d'utilisateur télécharger pdf (Page 59)

Tuba Installation Guide Installation

MAN-TUBIG (Ver. 1.502)

www.elmomc.com

3.5. Powering Up

After the Tuba has been mounted, check that the cables are intact. The Tuba servo drive is then

ready to be powered up.

Caution:

Before applying power, ensure that the AC supply is within the range specified

for your specific type of Tuba.

3.6. Initializing the System

After the Tuba has been connected and mounted, the system must be set up and initialized.

This is accomplished using the Composer, Elmo’s Windows-based software application. Install

the application and then perform setup and initialization according to the directions in the

Composer Software Manual.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 78 79

Pas de commentaire

Elmomc AC Input Digital Servo Drives-Tuba Manuel d'utilisateur Page 59