Elmomc CANopen DS 301 Implementation Guide Manuel d'utilisateur télécharger pdf (Page 114)

Chapter 14: Error Control Protocol

For node guarding and life guarding, SimplIQ digital servo drives implement the

heartbeat mechanism, as defined by CiA DS 301, version 4.0. With this process, a CAN

slave can monitor other devices to determine if they are active, according to their

periodic heartbeat messages. The CAN slave can send heartbeats to consumers, which

may want to monitor if this slave is active.

Heartbeats are sent from the moment of initialization, even if the slave state is stopped.

Object 0x1016

is a list of heartbeats that must be accepted from external devices. Failure

to accept an expected heartbeat leads to behavior described by object 0x1029 and object

0x6007.

Non-acceptance of a consumer heartbeat message at the expected time is called a

“heartbeat event,” which creates an emergency only if the relevant bit of EMCY is set to 1

(see object 0x2F21).

A single emergency object may be transmitted per one heartbeat

event. The heartbeat event is reset by one of the following events:

 A new heartbeat message arrives from the producer.

 The heartbeat consumer time object (0x1016) is written.

SimplIQ digital servo drives use a minimal implementation of object 0x1016. The sole

heartbeat that it monitors is that of the network master. Object 0x1017 sets the period for

sending heartbeats.

A heartbeat is a single-byte message, with the following options:

Heartbeat Description

0 Boot-up

4 Stopped

5 Operational

127 Pre-operational

The COB-ID for a heartbeat message is 0x700 + Device ID. For example, a first servo drive

with the unit ID of 1 will have heartbeat COB-ID of 0x701 = 1793.

CANopen DS 301 Implementation Guide Error Control Protocol

MAN-CAN301IG (Ver. 2.1)

14-1

1 2 ... 109 110 111 112 113 114 115 116 117 118

Pas de commentaire

Elmomc CANopen DS 301 Implementation Guide Manuel d'utilisateur Page 114